MODERNIZATION OF MOLD MANUFACTURING TECHNOLOGY TO INCREASE SERVICE LIFE IN THE BOTTERO E-IS GLASS FORMING LINE

Otajonov Murodjon Maqsud o’g’li

Fergana State Technical University

Gafurov Akmaljon Mavlonjonovich

Fergana State Technical University


Abstract

Introduction

The glass container industry represents one of the most technologically advanced sectors of modern manufacturing. Glass containers are widely used in food, beverage, pharmaceutical and chemical industries due to their chemical stability, recyclability and environmental safety. Modern glass production plants operate using automated forming systems known as Individual Section (E‑IS) machines. These machines shape molten glass into containers using metallic molds. In Bottero E‑IS forming lines molten glass at temperatures exceeding 1000°C is delivered to individual forming sections where the glass gob is transformed into bottles or jars. The shaping process relies heavily on the quality and durability of metallic molds. Molds determine the geometry, dimensional accuracy and surface quality of the final glass container. However, molds operate under extremely severe conditions including high temperatures, thermal fatigue, oxidation, corrosion and mechanical abrasion. Repeated heating and cooling cycles cause progressive degradation of mold surfaces. As a result mold replacement and maintenance represent a significant part of the operational costs in glass container production. Therefore modernization of mold manufacturing technology is an important direction for increasing productivity, improving product quality and reducing maintenance costs in modern glass manufacturing plants.


References

1. Davis, J. R. Surface Engineering for Corrosion and Wear Resistance. ASM International, 2001.

2. Pawlowski, L. The Science and Engineering of Thermal Spray Coatings. Wiley, 2008.

3. Ohring, M. Materials Science of Thin Films. Academic Press, 2002.

4. Mattox, D. Handbook of Physical Vapor Deposition (PVD) Processing. William Andrew Publishing, 2010.

5. Silva, F. J. G., Martinho, R., Alexandre, R., Baptista, A.

Improving the Wear Resistance of Moulds Using PVD Coatings.

Coatings Journal, 2017.

6. Fernandes, F., Ramalho, A., Loureiro, A., Cavaleiro, A.

Wear Resistance of a Nickel-Based Coating Deposited by PTA on Grey Cast Iron.

Surface and Coatings Technology.

7. Akhtar, A., Ruan, X.

Review on Thin Film Coatings for Precision Glass Molding.

Materials Science Review, 2022.

8. Tejero-Martin, D., Rezvani Rad, M., McDonald, A., Hussain, T.

Thermal Sprayed Functional Coatings: A Review.

Surface Engineering Review.

9. Höganäs AB.

Surface Coating and Thermal Surfacing for Glass Mould Industry.

10. Callister, W. D., Rethwisch, D.

Materials Science and Engineering: An Introduction. Wiley, 2018.

11. Kutz, M.

Handbook of Materials Selection. John Wiley & Sons, 2002.

12. Totten, G.

Handbook of Mechanical Alloy Design. CRC Press, 2006.

13. Levinson, S., et al.

Surface Engineering Applications in High-Temperature Industrial Equipment.

14. ASM Handbook.

Volume 5: Surface Engineering. ASM International.

Most read articles by the same author(s)